Common questions

How much differential fluid do I need Ford Ranger?

How much differential fluid do I need Ford Ranger?

The owner’s manual for the 2019 model year states 80W-90 fluid and 3.04 pints for a locking axle.

What fluid goes in a ford 8.8 rear end?

Ford revised the recommendations for 8.8s to use 75w140. Any synthetic of choice will be ok. I personally have had good results with mobil1, redline and amsoil.

What kind of gear oil does a Ford Ranger take?

Royal Purple 01300 Max Gear 75W-90 High Performance Synthetic Automotive Gear Oil , 1 Quart (32… Always use luca 80w-90 in ford ranger 2.3l, 7.5″ rear diff.

How do you check the differential fluid on a Ford Ranger?

To Check The Fluid Level:

  1. Make sure the transmission is in P (A/T) or in gear on a manual, then FIRMLY set the parking brake and block the drive wheels.
  2. Check under the vehicle to see if there is sufficient clearance for you to access the filler plug on the side of the differential housing.

What happens when you don’t change your rear differential fluid?

If this fluid isn’t changed in the manufacturer-prescribed intervals, then it can get dirty and thick, which could damage the differential over time.

How do I know if I have a limited slip differential?

The easiest way to tell if you have an open differential is to jack up the car and spin one of the rear tires. If the other wheel spins in the opposite direction, you have an open differential. If it spins in the same direction, you have a limited slip differential, or LSD.

How do you fill transmission fluid in a Ford Ranger?

Start the truck and let it run for 2 minutes and then, holding the brake, shift it through reverse and drive, hesitating for 30 seconds in each position. Put the transmission back into neutral. With the engine running and the transmission in neutral, check the fluid and fill as needed.

How to check front axle fluid in Ford Ranger?

The 1998 and newer Ford Ranger uses a different style front axle assembly than the 1983-1997 models. To check the fluid in these differentials, you have to remove the fill plug on the drivers side of the differential.

What kind of differential did a 1999 Ford Ranger have?

The 1999 Ranger had an optional four-wheel-drive system and a limited-slip rear differential available. When servicing the rear differential, it is important to know its capacity and the type of fluid needed to prevent damage to the axle.

What kind of lubricant do you use on a 1998 Ford Ranger?

Refill the drive axle housing using the proper grade and quantity of lubricant. Install the filler plug, operate the vehicle and check for any leaks. The 1998 and newer Ford Ranger uses a different style front axle assembly than the 1983-1997 models.

How do you change the oil in a Ford Ranger?

Although some fluid can be removed using a suction gun, the best method is to remove the axle housing cover (if equipped) to ensure that all of any present contaminants are removed. As with any fluid change, the oil should be at normal operating temperature to assure the best flow and removal of fluid/contaminants.