What is the proper string height on Fender Telecaster?
Action
| Neck Radius | String Height Bass Side | Treble Side |
|---|---|---|
| .7.25″ | 5/64″ (2 mm) | 4/64″ (1.6 mm) |
| 95″ to 12″ | 4/64″ (1.6 mm) | 4/64″ (1.6 mm) |
| 15″ to 17″ | 4/64″ (1.6 mm) | 3/64″ (1.2 mm) |
How high should nut be on Telecaster?
String Action at Nut It is best to start slow and a little higher to make sure you don’t go too low and cause the string to buzz on top of the first fret when played open. A good place to start is at the factory heights which are 1.5/64″ or . 022″ for the Low E, A, D, and G strings, and 1/64″ or .
How do I fix the intonation on my Telecaster?
Setting Intonation on a Tele
- Pick the open string and verify it’s in tune.
- Fret at the 12th fret and pick this note.
- If the 12th fret note is flat, move the saddle forward a little by turning the adjustment screw at the back of the bridge (counter-clockwise) using a flat or philips screwdriver (whatever is appropriate).
How do you stop fret buzzing?
5 Ways to Cut the Buzz
- Fret in the Right Place. Make sure you’re fretting notes at the proper spot just behind the fret.
- Apply the Right Amount of Pressure.
- Avoid Strumming Too Hard.
- Consider the Strings.
- Check the Setup.
How do you set the intonation on a Telecaster?
Is it hard to Intonate a Telecaster?
But by today’s standards, a Tele is simply not gig-worthy if you can’t intonate it. Fig. 2: This guitar came from the factory with period-correct straight-bar saddles. Unfortunately, such saddles are impossible to intonate accurately.
What should I know about setting up a Fender Telecaster?
Today we are going to go through the basic setup of a Fender Telecaster guitar. It is one of the more straightforward instruments to adjust, but not free from its own special set of little problem areas or headaches that we will address in this article. The first step in setting up a telecaster, or of any guitar, is the initial evaluation.
Where is the Allen key on a Fender Telecaster?
Locate the adjustable end of the truss rod. On this guitar it is at the head of the guitar and requires a 4 mm Allen key, though your guitar may be different. On some Teles, it is located at the other end of the neck.
How do you set up a Fender Stratocaster?
This must be done with the strings tuned to whatever pitch you usually use. If your neck is too bowed (the gap you just measured is too big), you tighten the truss rod by turning the Allen key (Allen wrench), screwdriver, or socket (the tool required depends on your guitar) clockwise.
Where is the tone knob on a Fender Telecaster?
Simply by setting the tone knob in the middle, then adjusting it up or down as desired while you play seems to work quite well. This might seem obvious, but if you’re used to playing almost any other type of electric guitar, your mindset may be to start with the tone knob mostly full on, then backing it down from there.