How to install quagga ospfd on FreeBSD 11?
To start, here’s a drawing of the configuration: VPS2, 4 and 5 are in datacenter 2. We want the traffic between hosts in the same datacenter at a lower cost than the traffic that traverses between datacenters. Installing Quagga’s OSPFd on FreeBSD is as easy as pkg install quagga. Next, you’ll need to enable IP routing.
How to use OSPF with quagga and bird?
OSPF is a routing protocol to help you propagate ip routes. I propose to show you a minimalisticinstallation of 3 hosts talking to each other with ospf: I am purposely giving the minimum set of instructions to get the hosts started as OSPF neighbors. A- Cisco router (ip:10.0.0.1) B- FreeBSD using Quagga net/quagga(ip:10.0.0.2)
How to move jails between hosts in FreeBSD?
In my use case, each FreeBSD system hosts a few jails. Each jail is given its own /32 IP address on the loopback interface lo2. With OSPF, we can move jails between hosts in different locations and OSPF will advertise the host’s IP route wherever the jail is running.
How to install the X Window System in FreeBSD?
An installation of FreeBSD using bsdinstall does not automatically install a graphical user interface. This chapter describes how to install and configure Xorg, which provides the open source X Window System used to provide a graphical environment. It then describes how to find and install a desktop environment or window manager.
Can you install Xorg as a binary on FreeBSD?
On FreeBSD, Xorg can be installed as a package or port. The binary package can be installed quickly but with fewer options for customization: To build and install from the Ports Collection: Either of these installations results in the complete Xorg system being installed.
Can a droidcam be ported to FreeBSD Linux?
DroidCam uses the v4l2loopback kernel module on Linux, which has not been ported to FreeBSD. So, despite DroidCam for Linux being open-source, the prospects of porting it, or any program using a non-local webcam, to FreeBSD are slim without v4l2loopback .